Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 24, 2005 at 2:23 pm #11360
    PCorrigan
    Participant

    When I run /Go RunProc nothing happens. I just return to the same location. No pop-up window or anything. Any ideas?

    March 26, 2005 at 4:31 pm #12754
    HMah
    Participant

    Does anything happen when you press just the / key?

    When going through the Windows setup, if you change the default setting from “United States” to “Canada” the keyboard will not recognize the / key in NV.

    Only solution I know is to Re-Install Windows and leave the default as US.

    Post Edited (03-26-05 13:16)

    March 28, 2005 at 12:20 pm #12757
    MSchappler
    Moderator

    Go to your procedures document and issue /Document Expand (/DE). If there are no procedures then cursor down once and type GETLIB and then issue /Document Expand (/DE) and then cursor down twice (make sure the top line says Procedure: if not then issue /Document View P for procedures (/DVP.))

    Issue /Block Import (/BI) GETLIB and press enter.

    Now you can issue /GR GETLIB. Type NV1 and press enter to bring in the NV1 library.

    Regards,

    Martin

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.